Kingston Memory HX318C10FW/4 4GB DDR3 1866 Unbuffered HyperX Fury White Retail

Part # 232999

Condition : New | Warranty : 90 days

Brand : Kingston
0 review | Add Your Review







HyperX HX318C10FW/4 is a 512M x 64-bit (4GB) DDR3-1866 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory module¸ based on eight 512M x 8-bit DDR3 FBGA components. This module has been tested to run at DDR3-1866 at a low latency timing of 10-11-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:


Features:



JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

VDDQ = 1.5V (1.425V ~ 1.575V)

933MHz fCK for 1866Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 13¸ 11¸ 10¸ 9¸ 8¸ 7¸ 6

Programmable Additive Latency: 0¸ CL - 2¸ or CL - 1 clock

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit¸ sequential with starting address 000 only)¸ 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self-calibration through ZQ pin (RZQ : 240 ohm 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower than TCASE 85 C¸ 3.9us at 85 C < TCASE < 95 C

Asynchronous Reset

Height 1.291 (32.80mm) w/heatsink¸ single sided component


PnP JEDEC Timing Parameters:



DDR3-1866 CL10-11-10 at 1.5V

DDR3-1600 Cl9-10-9 at 1.5V

DDR3-1333 CL8-9-8 at 1.5V""
No details available
No reviews available

Copyright © 2024 All Rights Reserved. Interloper