• Storage:
  • Supports four SATA-II ports at 1.5Gb/s.
  • RAID 0, 1, 5, supported.
  • Single-channel master mode supports up to two IDE devices
  • Supports IDE drives & ATAPI-compliant devices

• Rear Panel I/O Ports:
  • (1) Stacked PS/2 mouse and keyboard ports
  • (2) Side-by-side RJ45 ports
  • (2) Stacked USB 2.0 ports
  • (1) 9-pin COM port
  • (1) 15-pin VGA port

• Internal I/O Interface:
  • (1) Floppy connector
  • (1) IDE connector
  • (4) SATA ports
  • (4) USB v2.0 ports (2 at rear, 2 via cable)
  • (2) COM ports ( 1 at rear, 1 via cable)
  • 2 x 9-pin front panel pin header
  • 2 x 6-pin header for front panel LAN LED and
    ID LED switch
  • 2 x 25-pin connector for IPMI SMDC card (M3291)

• BIOS:
  • AMI BIOS on 8Mbit LPC Flash ROM
  • SMBIOS 2.3.1, BBS 1.1 compliant
  • ACPI 2.0 and SRAT support
  • PXE via Ethernet, USB device boot
  • 48-bit LBA Support
  • PnP, DMI 2.0, WfM 2.0 Power Management

• Power:
  • Onboard dual 4-phase digital VRM
  • EPS 12V (24+8) power connectors

• Regulatory:
  • FCC Class B (DoC)
  • EPS12V / SSI v3.51 (24 + 8) power connectors

• System Management:
  • (2) EMC6D103S H/W monitor chips
  • Eight 3+1-pin fan headers support tachometer monitoring, six of them with smart FAN controlre & voltage monitoring
  • Watchdog timer support
  • Temperature and voltage monitoring

Motherboard Specifications

• Model:
  • Tyan Thunder K8HM (S3892G3NR) Dual Opteron Motherboard

• Processor Support:
  • Two µPGA 940-pin ZIF sockets
  • Up to two AMD Opteron 200 series processors
  • Integrated 128-bit Dual-Ch DDR memory controller
  • Supports Single and Dual Core processors

• Chipset:
  • ServerWorks BCM5780 + BCM5785 chipset
  • National PC87417 Super I/O chip

• Memory:
  • 128-bit dual channel memory bus
  • Sixteen (16) 184-pin 2.5-Volt DDR DIMM sockets
    (eight on CPU 1 and eight on CPU 2)
  • Supports register ECC/non-ECC type memory
  • Supports Single/Dual Rank mem. modules only
  • Supports DDR 266 / 333 / 400* memory
  • * DDR400 memory can be used, but due to design considerations, the max. speed it will run is DDR333

• Expansion Slots:
  • Two x16 PCI Express slots (each with x8 signal)
  • Two PCI-X 133/100 MHz slots
  • One PCI-X 100 MHz slot
  • One Tyan TARO SO-DIMM socket
  • One PCI 32-bit 33 MHz, v2.3 compliant slot

• On-Board LAN:
  • Dual GbE LAN (from BCM5780)
    - Embedded in BCM5780
    - Two 10/100/1000 RJ-45 LAN ports with LED
  • One Intel ® 82551QM fast Ethernet controller
    - One 10/100 RJ-45 LAN port with LED
    - Operating on 32bit/33 MHz PCI bus

• Optional Modules (SMDC/TSO Support):
  • - Renesas H8S2167 BMC controller
  • - BT, KCS, Logging support; IPMI-over-LAN
  • - Remote Power on/off and reset

• M7901/ M7902, Ultra 320 SCSI TARO card:
  • - Adaptec AIC-7901/7902 single/dual-channel Ultra320 SCSI controller
  • - Adaptec HostRAID 0, 1, 10 supported

• M9000 SAS/SATA II TARO card:
  • - Adaptec AIC-9405/9410 SAS controller
  • - Supports up to 4-port (M9000-5) and 8-port
    ( M9000-10 ) SAS & SATA running at 3.0 Gb/s
  • - Adaptec HostRAID 0, 1 & 10 supported

• Integrated Video:
  • ATI ES1000 controller
  • 32MB DDR frame buffer

• Form Factor:
  • Extended ATX (12"x13"; 304.8x330.2mm)